Preparing to pull engine

Rear suspension installed

Sub-Frame Assembled & Ready to Install

Rubber bearing installation on rear sub-frame

new inner rubber bearing installed

pulling in rubber bearing using modified gear puller

new bearing with puller in background

tools used to pull bearing into trailing arm

left trailing arm installed

close up of axle attached to wheel bearing

inner control arm connection attached to sub-frame

outer control arm connection attached to sub-frame

new control arm rubber bearing installed

new sub-frame bearing mount installed into sub-frame

modified gear puller used to pull bearing into sub-frame

page showing sub-frame bearing mount installation

Rear suspension paint job

rear trailing arms prepped and ready for paint

detail showing weld on center area. Great welding done by neighbor Paul

paint on trailing arms

painting on POR 15 rust inhibitor

finished paint job on rear sub-frame

Rear end suspension disassembly

axle support during trailing arm removal

rear trailing arm off

axle shaft end

trailing arm inner connection

trailing arm outer connection

rubber sub-frame mount removed

axle connecting bolt

trailing arm connections to sub-frame

rear drive shaft flex disk

differential propeller connection

drive shaft connection to differential


looking toward front with gas tank and rear suspension out

gas tank

driveshaft
rear suspension
axle and rear trailing control arm

rear torsion bar connector